Here are some simple steps to install your new WindTrimmer  device.  It seems a bit complicated at first, but with a bit of practice you'll be able to do it in less than a minute!

1. Remove the protective  facing from both sides of the WindTrimmer device.
2. Thread the two Velcro attachment straps through the two upper slots, making sure that the hook side of the Velcro, which is rough to the touch, faces up, and the loop, or soft side, faces down.
3. Pull the Velcro strips through the upper slots so that all but roughly 6” of the Velcro strips has been pulled through.
4. Lower the hooding.
5. Raise both headrests approximately 2 inches above the seat back.
6. Position yourself on the right hand side of the car, slightly to the rear of the seat back.
7. Hold the WindTrimmer in your left hand with the longer end of the Velcro facing forward and in your right hand.
8. Align the top slot of the WindTrimmer near the top of the rear of the headrest.
9. Loop the long end of the Velcro strap around the front of the headrest and then under the headrest and through the lower slot of the WindTrimmer.
10. Quickly secure one end of the Velcro strap to the other.  At this stage you needn’t over tighten.
11. Go to the left side of the car and repeat steps 6 –10, positioning the WindTrimmer with your right hand, while maneuvering the Velcro strap with your left hand.
12. With the straps loose you can easily adjust you seat positions forward and back.
13. If your seats are positioned comfortably, snug up the Velcro straps so that the WindTrimmer is firmly pressed against the rear of the headrest, with the lower slots lining up with the bottom of the head rests.
14. Lower the headrests to their normal position.
15. Take your Morgan out for your most enjoyable ride ever!